Search results

  1. W

    Asheville Hardware Classes

    I know asheville hardware is a sponsor of this site but I must vent a little. I took a basic turning class in April of this year and while I was there I signed up for the bowl turning class in May. The class went well and I asked the instructor if he would be teaching the class in May. He said...
    • Wilson
    • Thread
    • asheville classes hardware
    • Replies: 2
    • Forum: Woodturning
  2. W

    Need 5/4 hard maple

    Thanks, for the replies. I'm still looking. The hardwood store and Thomasville are a little to far to drive. The cost of gas will add to much for 20 to 25bf cost. Wilson
  3. W

    Need 5/4 hard maple

    I need about 20 to 25bf of 5/4 hard maple. I can get 4/4 locally. I called Steve Walls ad found out that I have to order 100bf to be shipped to get the advertised price. To get this small amount will be over $5/bf. Atone know of a source near Shelby,NC? Thanks Wilson
    • Wilson
    • Thread
    • 5 or 4 hard maple
    • Replies: 7
    • Forum: Wood
  4. W

    Replacing deck boards

    Buy or borrow a bow wrench. Wilson
  5. W

    Which chuck?

    Thanks for the input. I just ordered the super nova. It looks like everyone that has a nova likes it and it's on sale now. Thanks Wilson
  6. W

    Which chuck?

    Andy, The instructor said he had a Barracuda and did not like it. I don't remember his complaint but will try to find out. Wilson
  7. W

    Which chuck?

    I just took a basic woodturning class last week. I am going back next month to take a bowl turning class. I want to go ahead and get a chuck for bowl turning. The instructor recommended a "Oneway or Nova". He recommend that we stay away from the Barracuda. Woodcraft currently has the SuperNova...
  8. W

    Drum sanders

    Thanks for the info. I will look on craigslist. I believe the general has variable speed on it's feed like the woodmaster. I read one review on a doubledrum sander and the person stated it was difficult to get both drums adjusted and he only used one of the drums. I also agree that you should...
  9. W

    Drum sanders

    I will use it to sand raised panel doors, panel glue ups that will fit in the sander, end grain cutting boards. The wood master is a little bigger and I like that it does not use clips to hold the paper to the drum but for a difference of about a thousand dollars I am leaning toward the single...
  10. W

    Drum sanders

    Hello everyone, I'm new to the site. I am wanting to purchase a drum sander. I am looking at the Woodmaster 26" model for about $2400, General single drum 24" for about $1400 and the General double drum 24" for about $2000. From what I have read I want to stay away from the opened ended models...

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top