I have recently RE-setup my Grizzly 17" bandsaw and made sure its on the highest speed, but no matter what type of wood I have it seems to drift AND burn the sides of the wood. anywhere from .5 inch and up to 2" causes this same drift - which always seems to be to the inside. I watch videos on youtube of people just plowing through wood with little to no effort and making straight and curved turns without much effort... this is frustrating.
I have checked the blade is centered on wheels, guides are within .004ish of the blade on all sides, blade is square to table from front to back and side to side. Its a standard blade from Grizzly and I havent had a chance to buy a NEW one yet.
Any ideas of what I should be checking on to fix this problem?
I have checked the blade is centered on wheels, guides are within .004ish of the blade on all sides, blade is square to table from front to back and side to side. Its a standard blade from Grizzly and I havent had a chance to buy a NEW one yet.
Any ideas of what I should be checking on to fix this problem?